![]() ![]() I randomly shorted out some resistors and capacitors nearby the eMMC but without luck. Some guides suggest to short out some pins on flash chip but my eMMC has BGA package so this was not possible. The box was in a boot loop without accepting any input or keystrokes. "Synchronous Abort" handler, esr 0x96000210 Init bus_cycle=6, bus_timing=7, system=5.0ns NOTICE: B元-1: Built : 11:25:15, Aug 25 2017ĮRROR: Error initializing runtime service opteed_fast So I hooked up serial interface to see what’s going on inside and the result was following: GXL:BL1:9ac50e:a1974b FEAT:ADFC318C POC:3 RCY:0 EMMC:0 READ:0 0.0 CHK:0 I also wrote to the seller to get help, they’ve sent me USB Burning Tool, factory image and Upgrade instruction which was nice but it didn’t work either. I tried all voodoo recovery instructions (holding reset button, powering from both usb and adapter, with HDMI, without it…) to boot into upload mode where the box would be detected by a PC and I would use USB Burning Tool but nothing helped. The LED was blinking red-blue and the box stopped booting. I wanted to use LibreELEC so I followed installation howto: downloaded and burned latest image to SD card, replaced dtb file with gxl_p212_1g.dtb, and run reboot update from Android terminal.īox rebooted into working LibreELEC, nice! Now I wanted to burn it into internal eMMC so I run installtointernal despite a big red warning on howto page and warning in the script itself, rebooted and… I got sad. After assembling and turning it on, Android 7 popped up but this was not my target OS. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |